4/21/2021 0 Comments Geze Slimdrive Emd Manual
Failure to observe this information may result in injuries and damage Danger of electric shock.The Slimdrive SL-FR 2M is approved for use in escape and rescue paths.
Preparing runner When measuring out the drive centre, keep drive extension in mind 1. Geze Slimdrive Emd Install It WithPlace the geared motor (1) on two sliding blocks at a distance U2 (see block diagram) from the centre marking and install it with an M6 x 20 Verbus-Ripp locking bolt. Place the locking device on two sliding blocks at the correct distance (see block diagram) from the deflection pulley and screw it down with M6 x 16 Inbus-Ripp locking bolts. Calculate toothed-belt length using the formula in the block diagram. For 2-leaf doors, two toothed belts: Left toothed belt (deflector) Right toothed belt (motor) For 1-leaf doors, one toothed belt. Slimdrive SL: DCU1 controller Slimdrive SL-FR 2M:DCU1-2M controller 3. Tighten bolts. Installing battery Position battery (1) (see block diagram) and install with M6 x 8 Inbus-Ripp locking. Clean running surfaces of the runner and rollers before using the roller carriage. Installing (optional) special roller carriage The special roller carriage prevents tipping. Insert the mounting elements (1) for cords (rubber cables) at the left and right in the front groove (3) of the hood approx. Lay rotary transducer cable (1) and motor connection cable (2) to controller. Push the plug into the controller. When performing maintenance work, the battery must be disconnected from the controller Check whether the battery cable (1) is long enough. Number: 2-leaf: 3 supports 1-leaf: 2 supports 3.24 Final work 1. You may need to cut out notches in the hood for the locking device (optional) (see drawing 70484-2-0572). During the operating test, the following fully-installed components of the drive are tested. Danger of crushing The door leaves are still unsecured and slide easily. Ensure that the door leaves are not pushed inadvertently or by unauthorised persons. Close the door leaves. Loosen the screws (1) and (2) on the locking device. Align the locking device to the toothed belt. After installation the locking pin must be positioned above the hole in the hood so that it can be locked and unlocked. Installing key switch The key switch is required with the Slimdrive SL-FR 2M The key switch is optional with the Slimdrive SL. The display program switch can be engageddisengaged with the key switch. With Slimdrive SL-FR 2M, the reduced opening width is only permissible if it is greater than the required width of the escape route (see Chapter 5.3). T When using a bolt lock, set the parameter to 4 before starting the Learn process.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |